Thingiverse
Linear Snap Connector
von walter
239
Downloads
183
Likes
0
Makes
Detachable connector used to replace a broken side release buckle on a dry bag with 3/4" webbing. The two pieces of the buckle are the same. Press together to close, twist or slide apart to open.
This design is not as secure as a standard buckle, but is much smaller. There are two versions, one for printing with ABS, another for printing with PET.
I'm not sure this part will work as-is on other printers, the tolerances need to be very precise for it to hold securely.
This design is not as secure as a standard buckle, but is much smaller. There are two versions, one for printing with ABS, another for printing with PET.
I'm not sure this part will work as-is on other printers, the tolerances need to be very precise for it to hold securely.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!