Thingiverse
link with holepattern, customizable
door DaveX
0
Downloads
0
Likes
0
Makes
This is an OpenSCAD file that can make a rounded end boss with holes or pins,
It was mostly an experiment with an array pattern aimed at a boss to fit a certain mechanical part, but you can use it make wheels, link-pins, etc...
If the boss has the the width equal to the length, it makes a disk. If the lenght is less than the width, it degenerates an dissapears
The pattern can be of holes or pins, with customizable numbers and spacing
It was mostly an experiment with an array pattern aimed at a boss to fit a certain mechanical part, but you can use it make wheels, link-pins, etc...
If the boss has the the width equal to the length, it makes a disk. If the lenght is less than the width, it degenerates an dissapears
The pattern can be of holes or pins, with customizable numbers and spacing
DaveX publiceert ook op
18 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!