Thingiverse
Litholamp
von icm1998
2
Downloads
3
Likes
0
Makes
This is my first upload! Hope you like it!
Use this link with the model settings shown on the picture for the photo print:
https://3dp.rocks/lithophane/
I first design the base to put a little candle thats why the post for the lights is separate.
For the light post to fit you will need to sand it a little or print it a little smaller.
Use this link with the model settings shown on the picture for the photo print:
https://3dp.rocks/lithophane/
I first design the base to put a little candle thats why the post for the lights is separate.
For the light post to fit you will need to sand it a little or print it a little smaller.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
