Lithophane Box
by MacLakey
43
Downloads
32
Likes
1
Makes
A simple triangular box for displaying 150mm square lithophanes that are no more than 4mm thick on the edges.
There is a depression in the center of the base for a tap light from the Dollar Tree.
The light is approximiately 69mm in diameter. (seriously, I didn't make that up.)
Once printed, the phanes should just slide down into the slots. Turn on the light, and then settle the top on.
*UPDATE* v2 of the base added. Now with cable port for wired electronics.
There is a depression in the center of the base for a tap light from the Dollar Tree.
The light is approximiately 69mm in diameter. (seriously, I didn't make that up.)
Once printed, the phanes should just slide down into the slots. Turn on the light, and then settle the top on.
*UPDATE* v2 of the base added. Now with cable port for wired electronics.
MacLakey also publishes on
27 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
