Lithophane Box
von MacLakey
43
Downloads
32
Likes
1
Makes
A simple triangular box for displaying 150mm square lithophanes that are no more than 4mm thick on the edges.
There is a depression in the center of the base for a tap light from the Dollar Tree.
The light is approximiately 69mm in diameter. (seriously, I didn't make that up.)
Once printed, the phanes should just slide down into the slots. Turn on the light, and then settle the top on.
*UPDATE* v2 of the base added. Now with cable port for wired electronics.
There is a depression in the center of the base for a tap light from the Dollar Tree.
The light is approximiately 69mm in diameter. (seriously, I didn't make that up.)
Once printed, the phanes should just slide down into the slots. Turn on the light, and then settle the top on.
*UPDATE* v2 of the base added. Now with cable port for wired electronics.
MacLakey veröffentlicht auch auf
27 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
