Lithophane stabilization tower

TESTED ONCE ON A LARGER LITHOPHANE. NOT SATISFIED WITH THE RESULT. A MORE STEADY VERSION COMING SOON...

Meant to prevent wobbling when printing large high lithophanes.

Approximately 130 mm high supports for flat large lithophanes to be put on each side.
90 and 112.5 degree supports in case the printing has to be done diagonally to fit on the build plate.

Import the .stl file twice in the slicer and use x-ray view to rotate and move them on each side of the lithophane and leave about 1 mm of the thinnest part outside. That way the supports be can be easily snapped off.

Use Pause at height or similar to stop the printing above the lithophane if the supports are higher than the image.