Lithophane Tutorial

Easy to print picture that shows surprise under light! Printing instructions - use white filament!Use either 100% infill or many walls/perimetersRecommended layer height is 0.12 however if you want the most detailed print, go lower. Maximum layer height in my opinion is 0.2Use BRIM and print in given positionNo supports In case you want to do your own lithophanes, here is how I did itFind suitable picture - good contrast; usually simpler picture prints better than one with lots of detailsoptional - use photoshop or any editing software (like the one in your phone gallery) and boost contrast, play with vibrance, saturation and sharpness.3. Upload your image to 3dp.rocks - on top click “Images” and upload yours then move to “Model” where you choose the type (curved, flat..) and hit refresh.4. All there is left to do is change “Settings” - I use the one below this paragraph. The most important is “Maximum size (MM)”, that changes the model size. After any change you need to click REFRESH