Thingiverse
Lithops Pot
von R3DB34RD
10
Downloads
3
Likes
0
Makes
This is a planter for Lithops based on 3Dponics Cube System.
Air holes on the side, drain holes on bottom and a back plate for label maker labels.
I plan to scale mine up a bit, same width but 90mm tall and a bit longer.
Please share a picture if you print. :)
Air holes on the side, drain holes on bottom and a back plate for label maker labels.
I plan to scale mine up a bit, same width but 90mm tall and a bit longer.
Please share a picture if you print. :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!