Thingiverse
Little plectrum pot
von Jeroverh3
0
Downloads
0
Likes
0
Makes
Plectrum pot for storing yeah... your plectrums?
There's a boolean modifier which is disabled(turn it on if you want to see it) in Blender which subtracts my initials, yes you can change the font or text!
If you print this object, please print the largest flat surface of the lid pointed down for best results. Also print in high settings or you'll get a loose lid... :D
If you use Cura set the largest length on 3,8 cm.
There's a boolean modifier which is disabled(turn it on if you want to see it) in Blender which subtracts my initials, yes you can change the font or text!
If you print this object, please print the largest flat surface of the lid pointed down for best results. Also print in high settings or you'll get a loose lid... :D
If you use Cura set the largest length on 3,8 cm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
