Thingiverse
TAZ 6 Tool holder
by Zimlorog
72
Downloads
43
Likes
1
Makes
Tool holder for stock TAZ 6. No modification or tools required for installation; arm for added security. **Now with SD card slots, small cutout for pens or screwdrivers, and hook for holding light objects!**
Built-in supports were tested at .4 layer height.
However adding custom supports in Cura is very easy. Use the provided Custom Cube, and illustration in the image gallery to create a good support foundation. I used a 20% connected Zig Zag support, with interface. Be sure to set your Support settings first, then disable supports; your custom supports will apply what you've set. Any Q's on how to use custom supports, feel free to leave a comment.
**Last minute revision idea: a version without the arm, and one with a few SD card slots. Check back in a few days.**
**3/7/18 - Almost done adding the SD card caddy, and armless versions! Should be done tomorrow.**
Built-in supports were tested at .4 layer height.
However adding custom supports in Cura is very easy. Use the provided Custom Cube, and illustration in the image gallery to create a good support foundation. I used a 20% connected Zig Zag support, with interface. Be sure to set your Support settings first, then disable supports; your custom supports will apply what you've set. Any Q's on how to use custom supports, feel free to leave a comment.
**Last minute revision idea: a version without the arm, and one with a few SD card slots. Check back in a few days.**
**3/7/18 - Almost done adding the SD card caddy, and armless versions! Should be done tomorrow.**
Zimlorog also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
