Thingiverse
Loading Tool
von Tormentor22
87
Downloads
47
Likes
0
Makes
A little loading tool suitable for the Pax3 Vaporizer and for sure many others. The tamp and the spoon got a diameter of 8mm, so check your Vaporizer if this tool fits.
I print it vertical. Where it goes into the spoon there´s a little overhang. My printer managed this without support.
Use a brim with 15 or more outside lines. You need a good stand, otherwise maybe it will come off.
Print it with 100% infill. It will give the whole thing more stability.
I print it vertical. Where it goes into the spoon there´s a little overhang. My printer managed this without support.
Use a brim with 15 or more outside lines. You need a good stand, otherwise maybe it will come off.
Print it with 100% infill. It will give the whole thing more stability.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
