Thingiverse
Lockable Bolt Latch
door Anthony1313Lopez
17
Downloads
26
Likes
0
Makes
I made a lockable door bolt latch that is bulky by design.
Print with your desired parameters.
The wings on the slides are blank so you can add any holes for screws, washers, etc.
Parts can be printed without supports.
----------------------------------------------
Main slide is 70mm L x 100mm W x 35mm H, Recommend print on SIDE.
End slide is 30mm L x 100mm W x 35mm H, Recommend print FLAT.
Bolt hole for lock is 10mm Diameter.
Bolt handle can be friction fitted into bolt, use glue if needed.
Print with your desired parameters.
The wings on the slides are blank so you can add any holes for screws, washers, etc.
Parts can be printed without supports.
----------------------------------------------
Main slide is 70mm L x 100mm W x 35mm H, Recommend print on SIDE.
End slide is 30mm L x 100mm W x 35mm H, Recommend print FLAT.
Bolt hole for lock is 10mm Diameter.
Bolt handle can be friction fitted into bolt, use glue if needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
