MakerWorld
Jewelry
Zum Modell
Lockable Heart Container
72
Downloads
39
Likes
35
Makes
This Heart Container is lockable! With a twist of the small heart, you will have access to whatever is stored inside. POST PROCCESSING:the supports in the box will be easy to remove. If you have trouble on the lid, push the long rack (rectangle with teeth) through and the supports should release themselves. When assembling, put small heart, facing up, through the lid, then align the racks as shown in the picture. Finally place the gear on top of the axle and press hard. It may be difficult, however that it necessary to make sure that it stays on.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!