Locker Buddy

You are looking at a print I like to call "Locker Buddy". It was used on my locker at work, and seeing it worked so well I decided to upload the files here for anyone that might get some use out of them. It was designed to fit inside the door of my locker, but can be placed anywhere that you can attach it to. I attached it to my locker using 2 Neodymium magnets (60 x 10 x 3 mm), they were rated for 12LB of holding strength, but seemed to be weaker than that. If you decide to use the exact magnets I did, I have included an indentation on the back of the container to where to place the magnets. I have also included a lip at the bottom of the container, which is equal to the thickness of the magnet, so the container will sit flush. If you use different magnets you will need to adjust the thickness of the lip to match the thickness of your magnet.

Thank you for taking the time in viewing my model.