Thingiverse
Locking ball and socket arm
von alexrich82
5.9k
Downloads
4.2k
Likes
12
Makes
#Want to support me?#
Interested in the PCB holder shown in the picture and want to support me? Check out Stickvise, my low profile soldering vise:
- Information: http://www.stickvise.com
- Buy it on Amazon: http://amzn.to/2dgmQCE
#Summary#
Ball and socket system, upgraded with a quarter turn twist lock on each ball joint to greatly increase pullout strength.
My idea is to create a ball and socket system that is not only 3d printable but extremly strong and will not pop apart easily. This would be suitable for things like an LED lamp arm or heavy duty alligator clip where you don't want the neck popping apart.
My original project was posted on hackaday:
https://hackaday.io/project/5739-locking-ball-and-socket-gooseneck-system
**Update 5/17/15**
New STL files posted on 5/17/15 - should work much better on printers with larger layer height / lower resolution
Interested in the PCB holder shown in the picture and want to support me? Check out Stickvise, my low profile soldering vise:
- Information: http://www.stickvise.com
- Buy it on Amazon: http://amzn.to/2dgmQCE
#Summary#
Ball and socket system, upgraded with a quarter turn twist lock on each ball joint to greatly increase pullout strength.
My idea is to create a ball and socket system that is not only 3d printable but extremly strong and will not pop apart easily. This would be suitable for things like an LED lamp arm or heavy duty alligator clip where you don't want the neck popping apart.
My original project was posted on hackaday:
https://hackaday.io/project/5739-locking-ball-and-socket-gooseneck-system
**Update 5/17/15**
New STL files posted on 5/17/15 - should work much better on printers with larger layer height / lower resolution
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
