Thingiverse
Locking latch
von a-python-script
83
Downloads
55
Likes
0
Makes
The locking bolt is designed to slide into a hole, therefore there is no counterpart (e.g. a retaining clip) for it. A 4mm hole must be drilled into which the latch can slide (~15mm deep).
**Update 03th Sept 2023**
I slightly decreased the size of the inner slider for better sliding behavior.
**Update 03th Sept 2023**
I slightly decreased the size of the inner slider for better sliding behavior.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
