Thingiverse
Locking Pannier Hook
von aerialcopper
105
Downloads
92
Likes
0
Makes
These are spring-loaded clips for a bike bag, similar to ortlieb's style, for DIY bicycle panniers. I made it parametric and uploaded hooks ("hook" "latch") and bottom clips ("leaf") for different diameter rack tubing. The diameter in file name is finished printed size- so round up when you choose which size to print. This design works really well, but it is also complex. You need:
-m3 x 35mm SHCS for pivot
-m3 tap (optional)
-m5 x ??? for mounting holes. Bottom hole is countersunk for flat-head m5 screw.
-m5 tap if you want to use top mounting holes
-wire for spring. I used .6mm/.022” dia spring steel which is the right amount of spring tension. Wrapped (3) turns around a 4.5mm shaft to produce the spring. Leave the spring tails 4cm long or so, so you can assemble it. Once the ends are trimmed, it is VERY difficult to reassemble. There is room for variation in spring, use what you can find.
-paracord. The ends are threaded through the hook, and melted till the tip balls up. Th
-m3 x 35mm SHCS for pivot
-m3 tap (optional)
-m5 x ??? for mounting holes. Bottom hole is countersunk for flat-head m5 screw.
-m5 tap if you want to use top mounting holes
-wire for spring. I used .6mm/.022” dia spring steel which is the right amount of spring tension. Wrapped (3) turns around a 4.5mm shaft to produce the spring. Leave the spring tails 4cm long or so, so you can assemble it. Once the ends are trimmed, it is VERY difficult to reassemble. There is room for variation in spring, use what you can find.
-paracord. The ends are threaded through the hook, and melted till the tip balls up. Th
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
