Thingiverse
Logitech C270 Mount (Camera Thread)
por SolarMill
8
Descargas
3
Likes
0
Makes
This mount was designed for the Logitech C270 Webcam in order to thread onto an articulating arm, in this case to view a 3D print remotely.
After the file has printed, the large hole in the bottom will need a 1/4"-20 heat-set insert that is 0.5" long.
The printed hinge was attached to the camera with a M3 x 20 mm screw with a nylock nut on the other side keeping the camera from swinging in the hinge.
It can be mounted to a tripod or any standard camera mount. The magic articulating arm used in the pictures above can be purchased here:
https://www.amazon.com/gp/product/B074N2YTCY/
The LED Mod for the camera can be found here:
https://www.thingiverse.com/thing:2927508
After the file has printed, the large hole in the bottom will need a 1/4"-20 heat-set insert that is 0.5" long.
The printed hinge was attached to the camera with a M3 x 20 mm screw with a nylock nut on the other side keeping the camera from swinging in the hinge.
It can be mounted to a tripod or any standard camera mount. The magic articulating arm used in the pictures above can be purchased here:
https://www.amazon.com/gp/product/B074N2YTCY/
The LED Mod for the camera can be found here:
https://www.thingiverse.com/thing:2927508
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!