logitech c270 wall mount

[parts needed] m3x12 or longer bolt & a wood screw with a head size between 5 and 7 mm and a thread width under 4 mm.   [installation] remove the included mount by taking off the screw cover unscrewing the screw and sliding out the pin. screw the printed mount to the wall with the wood screw then align the hole on the back of the camera with the two holes on the mount then screw an m3 screw through the larger hole on the mount then through the hole on the camera than thread it into the smaller hole on the mount. tighten the m3 screw so that the camera is held firmly but not so tight that you cant rotate it up and down. if this is unclear feel free to ask questions  in the comments.   [print settings] print with 100 walls. print the max temp of your material. set minimum layer time to 30s with no cooling.