Longrunner IR Raspberry Pi Camera Case

Designed to fit the Longrunner Raspberry Pi infrared camera. There are similar cases to this for other cameras of the same shape, but they are all too small for the Longrunner camera version.

**Fitting**
Tap the screw towers on the bottom half with an M3 tap, then use 13mm M3 screws to attach the 2 pieces together. If you don't have a tap, drill out through the base and put a 16mm M3 all the way through it with a nut on the back.

**Post print**
The centre camera hole is a little tight, if your printer under-sizes things you might need to run a de-burrer around it.

**Coming soon**
There are slots on the back for the mount which at the time of publishing I've not built yet, but I'll add it when I've done it.

Hope this helps someone out!

Best

Matt