Thingiverse
Lora Amplifier Module Case
by GM4ISM
3
Downloads
4
Likes
0
Makes
Case for Chinese LoRa amplifier modules. These produce >1.6W driven by a T-Beam tracker (65mW) Supplied 5V with an old USB charging cable
The power connector must be removed from the board and the USB cable 5V power wires soldered in it's place.
Be sure to use a 5V power source If you fit a USB A plug, be aware that some chargers have an output greater than 5V for fast charging!
The amplifier unit is a close fit in the case. Only the 433MHz version has been tried
AliExpress description - You must select the correct band!
High Gain 433MHz 510MHz 868MHz for Lora Signal Booster Transmitting Receiving 2-Way Power Amplifier Signal Amplification Module
The printed strain relief for the power cord must be very carefully separated from its minimal supports. The hole will need to be cleaned out with a 3.5mm Drill to pass a 3mm diameter USB cable.
The lid is fixed by M2.5 countersunk screws. The holes in the case for the screws should be drilled out to 2mm and then the holes carefu
The power connector must be removed from the board and the USB cable 5V power wires soldered in it's place.
Be sure to use a 5V power source If you fit a USB A plug, be aware that some chargers have an output greater than 5V for fast charging!
The amplifier unit is a close fit in the case. Only the 433MHz version has been tried
AliExpress description - You must select the correct band!
High Gain 433MHz 510MHz 868MHz for Lora Signal Booster Transmitting Receiving 2-Way Power Amplifier Signal Amplification Module
The printed strain relief for the power cord must be very carefully separated from its minimal supports. The hole will need to be cleaned out with a 3.5mm Drill to pass a 3mm diameter USB cable.
The lid is fixed by M2.5 countersunk screws. The holes in the case for the screws should be drilled out to 2mm and then the holes carefu
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
