Thingiverse
Electronics
Zum Modell
LoRaDevBox
94
Downloads
73
Likes
2
Makes
A small 3D design to house the dev module, antenna, and rechargeable battery.
For this device from WishIoT: 868MHz-915MHz SX1276 ESP32 WiFi Bluetooth LoRa Module Development Board with 0.96 OLED Display
Buttons are simply cut-outs that flex over buttons on the device.
Includes hole for a USB micro programming or charging cable.
Designed in TinkerCad, then sliced using Cura.
Printed on an Ender-3 using Amazon Basics "copper" PLA.
For this device from WishIoT: 868MHz-915MHz SX1276 ESP32 WiFi Bluetooth LoRa Module Development Board with 0.96 OLED Display
Buttons are simply cut-outs that flex over buttons on the device.
Includes hole for a USB micro programming or charging cable.
Designed in TinkerCad, then sliced using Cura.
Printed on an Ender-3 using Amazon Basics "copper" PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
