LP Style Guitar

https://youtu.be/_nyhXNTSCrA

LP Style Guitar for printing on CR10 size bed (300mmx300mm). Scale all OBJs to 2540% in Cura. I modeled in inches and this resolves the unit size conversion. Print for strength.
I used 3mm walls and 50% triangle infill in Cura. The neck shim was the only thing I printed at 100% infill. There are Left Handed (Marked LH) and Right Handed Parts (RH).
I am left handed so that's what I made. Print parts laying flat. Thingiverse shows them vertical for some reason.

This is a LONG print. The front section of the body was 82.5 hours. The other body
sections were around 42 hours each. With this in mind I made the whole top
swappable so you can print different tops with out having to reprint the body sections.

I used about 2 rolls of black PLA (Tainse Brand) and less than half a roll of the Army Green. I plan to model additional tops in the future. Because this was a simple flat top the pick ups
may seem a little low. Adjust or raise them as you see fit