Lulzbot Mini Raspberry Pi Case

This is a Raspberry Pi 3 b case for the Lulzbot mini. Should fit Pi 2 as well ?

This screws onto the side of the mini using the existing holes in the frame. The USB ports are to the rear and the mem card slot at the front, with power out the top.

I use this to run Octoprint.

I looked around and found a nice case on GrabCad.
https://grabcad.com/library/raspberry-pi-2-and-b-case-with-vesa-mounting-1

I imported this to solidworks and changed to to suit the Lulzbot mini.

This included changing the mounting points to the rear of the case, to suit the mini frame.
I made the case deeper to allow the rear fixing and to get better airflow.

I also added lots of vent holes and added the Lulzbot & Octoprint logos etc.