Thingiverse
M3 Flight Controller Stack Wrench
door nickwkennedy
0
Downloads
0
Likes
0
Makes
A wrench for those annoyingly small nuts used to hold together a flight controller/ESC stack. This is for 5.5mm nuts, which is commonly used for M3 screws.
Infill doesn't matter too much, since the walls are going to be pretty thin. Its strong enough to get things tight, and if you break it you're probably putting things tighter than they should be.
Infill doesn't matter too much, since the walls are going to be pretty thin. Its strong enough to get things tight, and if you break it you're probably putting things tighter than they should be.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
