Thingiverse
M3D Filament Guide
por menerso
140
Descargas
90
Likes
8
Makes
Update: Checkout this thing... you can print 3 out at once.
http://www.thingiverse.com/thing:865138
This is a remix of http://thingiverse.com/thing:746048.
I made the clip twice as thick (total of 6mm) and I closed up the gap a bit more so it holds onto the M3D cable better. I left the filament hole the same.
The pictures above are 6mm thick, but I didn't tighten up the clamp part on those. It is tough to notice in a picture anyway, but it does help with the clamp pulling off the cable.
http://www.thingiverse.com/thing:865138
This is a remix of http://thingiverse.com/thing:746048.
I made the clip twice as thick (total of 6mm) and I closed up the gap a bit more so it holds onto the M3D cable better. I left the filament hole the same.
The pictures above are 6mm thick, but I didn't tighten up the clamp part on those. It is tough to notice in a picture anyway, but it does help with the clamp pulling off the cable.
menerso también publica en
33 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
