Thingiverse
M3x4 thread insert calibration
von nacho98
3
Downloads
1
Likes
0
Makes
Use this to check what size you should make your holes when using 4mm thread inserts.
Just print it, place an insert in each hole and see which one you like the most, for my type of insert it was 3.75 mm.
Just print it, place an insert in each hole and see which one you like the most, for my type of insert it was 3.75 mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
