Thingiverse
Macro Pad Case
von I_Sedlmyer
0
Downloads
0
Likes
0
Makes
PSU IEEE 2022 Macro pad Case
It uses some of the existing hardware that you got in the project.
There are just six screw holes located in the case to fix the electronics to the case.
I just stuck the rubber feet we got from the project on the bottom of the case and it works well.
For the best result print with the face of the case down on the print bed for smooth surface and no layer lines.
It uses some of the existing hardware that you got in the project.
There are just six screw holes located in the case to fix the electronics to the case.
I just stuck the rubber feet we got from the project on the bottom of the case and it works well.
For the best result print with the face of the case down on the print bed for smooth surface and no layer lines.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!