Mag Loader (cut down)

I used a random file found on the interwebs and cut it down to what I feel is the bare minimum needed. Print time should be around 7hrs total instead of the original at over 24.

The height was reduced and I later realized this was a mistake as the lips of the mag sat too high. To remedy that, place about 2mm thick piece of material under the loading edge of the first piece (pt1). See pic.

I don't remember exact printing details on my ender 3 pro, but I think 20% infill, .28 layer height, 3200 speed, 2 layer top/bottom and 2 perimeter.

Mount to a 2x4 being very careful not to drill through the sidewall of the feed channel.