Thingiverse
Magic Band + Stand Version 2
door imateo44
3
Downloads
16
Likes
0
Makes
Decided to try and make a charging station for Disney Magic Band+. Will accept 4 magic band chargers, with enough room to charge 4 bands at the same time, with the use of a USB hub.
This is my second try at this print. I was able to make the openings just a little tighter (you will need to press the chargers into the slots), also added the insets for the area around the charger itself. After printing, I noticed that I needed openings for my USB hub that I had, so I redid the print with these openings. It will still fit a usb hub inside the "tube" if you decide to go that route.
This is my second try at this print. I was able to make the openings just a little tighter (you will need to press the chargers into the slots), also added the insets for the area around the charger itself. After printing, I noticed that I needed openings for my USB hub that I had, so I redid the print with these openings. It will still fit a usb hub inside the "tube" if you decide to go that route.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
