Slicer Discord
Magic Jug – 3D-Druckmodell von Thingiverse Thingiverse
Magic Jug – Bild 1 Magic Jug – Bild 2
Learning

Magic Jug

68 Downloads
64 Likes
0 Makes
Zum Modell
A jug that "magically" refills itself. After you pour all of the contents out, you can set it down, and a few seconds later you can pour water from it again. In reality the jug has a double wall, with a small hole between the inner and outer chambers. A hole on the outside can be blocked with a finger while pouring, keeping the contents of the outer chamber from spilling into the inner chamber.
Kategorie
Learning
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen