Thingiverse
Magnetic Catch
by SuperSalty
1
Downloads
0
Likes
0
Makes
I printed this magnetic catch because the plastic parts on my window covers started breaking apart.
The measurements of this part are 50x15x5mm and it fits a 30x10x2mm flat magnet very snugly. It may be needed to widen the gap with a small knife, however I didn't need to make any adjustments after printing.
The screwholes fit a 7mm head and are a tight fit for a 3mm plastic/wooden screw.
The distance between the two holes ist approximately 40mm.
The measurements of this part are 50x15x5mm and it fits a 30x10x2mm flat magnet very snugly. It may be needed to widen the gap with a small knife, however I didn't need to make any adjustments after printing.
The screwholes fit a 7mm head and are a tight fit for a 3mm plastic/wooden screw.
The distance between the two holes ist approximately 40mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
