Magnetic Light Switch Covers

Just a little magnetic light switch cover. Fits US standard switches protruding up to 15mm out from the light switch plate face. Designed to print smoothly and quickly (model is built on multiples of standard line widths of 0.42mm). Takes one 8x3mm magnet in each side, the holes are actually ∅8.2mm and 4mm deep. Put a touch of CA glue on the bottom of the hole and press your magnets in (you can stack two to use one as a ram-rod) to leave a small recess so the screws in the light switch plate cover will fit inside them as they almost always poke out a little bit. UPDATE 20240729I'm adding to this a humidity switch cover that I later made for my kid's bathroom. Same principal, but fits over Decora sized plates and blocks the ability to press the button for automatic humidity switches with a maximum of 10mm internal clearance. Available with and without a “no touch” logo.