MakerWorld
Jewelry
Vai al Modello
Magnetic ring case
98
Download
72
Likes
74
Makes
Ring case using two circular 10x4mm or four 10x2mm magnets. After printing, stick the magnets, for example, using epoxy glue. The inner space for the ring has an inner diameter of 13mm, an outer diameter of 25mm.The second print profile uses 5x2mm magnets. Printer will pause for you to insert magnet. Remember to flip polarity on the second magnet you insert. No glue needed since the printer will seal it in. Also increased the depth so it will hold a men's 6mm wide ring. Thank @smoke.007 for this print profile.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
