MakerWorld
Other Hobby & DIY
Zum Modell
Magpul CTR cheek riser
78
Downloads
44
Likes
40
Makes
Magpul CTR cheek riserPrefer material: PETG, ABSPrefer infill: 25% Attention! This model should be fitted as precisely as possible to work correctly. To avoid excessive clearances caused by material shrinkage, I recommend scaling the model by the percentage value specific to the material you are using (Since the cooperating parts are on the inside, I recommend reducing the model's dimensions). If you notice excessive clearances in an already printed model, I recommend eliminating them, for example, by using electrical tape.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
