Thingiverse
Mailbox Flag
door jdpurcell
118
Downloads
79
Likes
1
Makes
Mailbox flag. Held together and attached with 2 screws/washers/nuts. Not sure exactly which screws I used but the thread diameter was roughly 5mm and head diameter 8mm.
It has a small nub to help keep the flag vertical. With my printer it came out just right, but if it's too hard to slide the flag, you could file it down a bit.
I recommend slicing at 0.2mm layer height.
It has a small nub to help keep the flag vertical. With my printer it came out just right, but if it's too hard to slide the flag, you could file it down a bit.
I recommend slicing at 0.2mm layer height.
jdpurcell publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!