Thingiverse
Maker Pipe Mini Adustable
door caver01
18
Downloads
7
Likes
0
Makes
Update 8/29/21
Printed now with PLA, models remade and oriented on their sides for strength.
Well, I took a crack at remixing the Maker Pipe Minis to get a working Adjustable. I think it worked!
Here are a few specs:
1. Same compatible dimensions for coffee stirrers (tested, works great).
2. Made the hinge out of what is basically a compressed through hole from a T. The mating part uses partial sphere “bumps” which you snap over the hole for a friction fit.
3. Rotates smoothly. If you want it to be solid, a drop of CA glue would do the trick.
4. Hinge works in full 180 degrees, so you can model parallel conduit.
5. Printed on side.
Please try them out and make improvements if you want. Perhaps there are better ways, but this seemed like the simplest.
Printed now with PLA, models remade and oriented on their sides for strength.
Well, I took a crack at remixing the Maker Pipe Minis to get a working Adjustable. I think it worked!
Here are a few specs:
1. Same compatible dimensions for coffee stirrers (tested, works great).
2. Made the hinge out of what is basically a compressed through hole from a T. The mating part uses partial sphere “bumps” which you snap over the hole for a friction fit.
3. Rotates smoothly. If you want it to be solid, a drop of CA glue would do the trick.
4. Hinge works in full 180 degrees, so you can model parallel conduit.
5. Printed on side.
Please try them out and make improvements if you want. Perhaps there are better ways, but this seemed like the simplest.
caver01 publiceert ook op
41 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
