Thingiverse
MakerBot Feed Spool
von unrepentantgeek
21
Downloads
42
Likes
1
Makes
Make sure to properly feed your MakerBot else it might get angry. This laser-cuttable feed spool will make the job easier.
Updated:
- Widened the base to make it more tolerant of skew
- Reduced the inner splines diameter to make it easier to load filament.
Updated:
- Widened the base to make it more tolerant of skew
- Reduced the inner splines diameter to make it easier to load filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
