Thingiverse
Makerbox Replicator 2X Duct Fan
von clearchrome
2
Downloads
0
Likes
0
Makes
Redesigned the filament Duct Fan to be able to print PLA.
No screws and no other special hardware needed.
The fan is not hitting the enclosure door as original design.
I used a Glue Gun the fan & holder and works very well
You can get yourself those special long hex screw if you are worried about not holding up.
Print it on the Side, tested on long term ,works great.
No screws and no other special hardware needed.
The fan is not hitting the enclosure door as original design.
I used a Glue Gun the fan & holder and works very well
You can get yourself those special long hex screw if you are worried about not holding up.
Print it on the Side, tested on long term ,works great.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
