Thingiverse
Marble Run Set
von ajbarry3
28
Downloads
23
Likes
0
Makes
I increased the interior diameter of the bottom end of the marble run set by .02% or about 0.5mm so they would fit together after printing on my FDM printers.
Tested with 15mm marbles
Some parts can print with supports while others do not
20% infill works fine
This is a remix and I don't have any commercial made pieces to test the fitting.
Tested with 15mm marbles
Some parts can print with supports while others do not
20% infill works fine
This is a remix and I don't have any commercial made pieces to test the fitting.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
