Marking Gauge

This here contraption in för marking wyyd. In fine wyyd wörking, there be often times when one must make a knife mark from certain distance from a end part of wyyd one works with and this here device is there to help thee.


A word of warning making this requires some pre purchased items and handiwork, printing these parts is only half the battle.


If you so choose to embark on this makers journey however, i'll suggest you purchase / have the following items in order to bring this gauge into fruition.

A drill, a fresh 10mm bit, and table/angle grinder with a fine sanding disk.

A length aprox. 20cm of 10mm ø pipe with inside ø of 8mm mine was aluminum tho steel would be preferred.

A M8 countersunk, flat head bolt, mine was 80mm long, but the longer the better, twss.

A Cap head socket screw/bolt M8 x 16mm (thread length) (see pic_2). This screw should be standard issue, but just incase ill post head dimensions: ø13mm, height 8mm, and 6mm hex hole.



Print parts