Thingiverse
marlin mag release
von rkevinball_5591
0
Downloads
1
Likes
0
Makes
Tried to buy this mag release for my Marlin model 25 Bolt (https://www.gunpartscorp.com/products/403110b) . It was not available. Also for the Marlin 780.
I look at the item and decided to create one. I printed it in PLA at 100% and after a few modifications I got it done. It works. works very well. You will need to find a spring and a pin. I used a cut down pen spring and a nail. Cut the spring down and push the nail through , cut and bend the end.
I look at the item and decided to create one. I printed it in PLA at 100% and after a few modifications I got it done. It works. works very well. You will need to find a spring and a pin. I used a cut down pen spring and a nail. Cut the spring down and push the nail through , cut and bend the end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
