Thingiverse
Mars
door Pohal
16
Downloads
8
Likes
0
Makes
Mars is printing while i'm posting this thing.
I used Blender to do this model.
I used heightmap from this website : http://planetpixelemporium.com/mars5672.html
I made a sphere, with a big subdivision, and used displacement modifier with the heightmap above. Voilà.
My print is 60mm diameter, printing at 0.2 precision, with 60° support on touching builtplate only. Also I move up a little bit the model on Z axis. (With Cura you have to uncheck a parameter to do so).
Infill is set to 20%, could be less.
The printing duration is about 3h.
There's no hole in this model like the moon (https://www.thingiverse.com/thing:4832282) because i didn't plan to light it up.
I used Blender to do this model.
I used heightmap from this website : http://planetpixelemporium.com/mars5672.html
I made a sphere, with a big subdivision, and used displacement modifier with the heightmap above. Voilà.
My print is 60mm diameter, printing at 0.2 precision, with 60° support on touching builtplate only. Also I move up a little bit the model on Z axis. (With Cura you have to uncheck a parameter to do so).
Infill is set to 20%, could be less.
The printing duration is about 3h.
There's no hole in this model like the moon (https://www.thingiverse.com/thing:4832282) because i didn't plan to light it up.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
