Slicer Discord
Master Line  – 3D-Druckmodell von Thingiverse Thingiverse

Master Line

von MarcoMT
51 Downloads
96 Likes
0 Makes
Zum Modell
The Master line has been designed and constructed so as to keep in order the lines of your kite. Compatible with all makes and models of kites to 4 (or 5 lines), the system has 4 (or 5) connectors, each consisting of two identical halves which mate to "embrace" every single line without squeezing it. During normal operation of each kite, the line will host a connector. At the end of the session, when separate lines by 'kite is sufficient to interconnect the elements of the Master line in the same order in which you disconnect from the kite. The system ensures that the lines do not cross and can always maintain the correct order to be reconnected to the kite without the need to unroll the entire length, avoiding any possibility of knotting or tangling the four lines.
https://www.youtube.com/watch?v=XCw6HihptwI
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen