Matrix Core from Deep Rock Galactic (OUTDATED)

This is a Matrix Core from Deep Rock Galactic that i modeled using photos and in game animations. It has screw on dials on the bottom and side so that different colour buttons can be used. On the left side of the screen there is a gap to slot in images on the different overclocks or cosmetics. It prints in 2 pieces that attach with pins and superglue or any other solvent.

The larger top piece i printed at 0.2mm with 20% infill on its back with supports everywhere. The supports are for the pin slots, threads and slot on the side. I would say its necesarry to have them for this part. The smaller bottom part i printed upside down with the same settings including supports, It is only necesarry for supports on the print bed only to ensure the threads are accurate.

For the pins and dials I used 0.2mm 100% infill but you can do anything. You may have to sand the pins down slightly as the tolerance is almost 0.

Rock and Stone!