Thingiverse
Mauler cable half
von JoeMaulerWorks
17
Downloads
11
Likes
0
Makes
not toy accurate
Need two of these fused together with abs solvent
Or merge two of these files in your software if your printer bed allows it.
I made it so that the end shackles can fit snug on the mauler front belly hooks
It does not fit the mobat rear tow hook
File is shown vertical... DON'T!!
I always print flat, horizontally
Need two of these fused together with abs solvent
Or merge two of these files in your software if your printer bed allows it.
I made it so that the end shackles can fit snug on the mauler front belly hooks
It does not fit the mobat rear tow hook
File is shown vertical... DON'T!!
I always print flat, horizontally
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!