Thingiverse
Mavic Controller Mount
por paramanch36
2
Descargas
0
Likes
0
Makes
When out flying my Opale Paramodels, I wanted to get some arial fottage of the wings in flight, Having had one go where placed the mavic in hover behind me I placed the controller down as needed to launch and fly the paraglider.
I set about making a mount that can be used on and Controller putter... AS in the images shows or any other mounting you might have
The Mount is held in place by double side tape and 2 tie wraps.. as shown in one of the images
Velcro straps are then fed through the holes in the mount and around the Mav Mount I use, (Can be used with Phoenes also for less weight (I tried the Galexy 8+ and worked well)
Gap in bottom area allows for the lead to be plugged into the bottom of controller
When not in use simply secure or remove the straps.
I set about making a mount that can be used on and Controller putter... AS in the images shows or any other mounting you might have
The Mount is held in place by double side tape and 2 tie wraps.. as shown in one of the images
Velcro straps are then fed through the holes in the mount and around the Mav Mount I use, (Can be used with Phoenes also for less weight (I tried the Galexy 8+ and worked well)
Gap in bottom area allows for the lead to be plugged into the bottom of controller
When not in use simply secure or remove the straps.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
