Mazda Connect Screen Visor

I will post a pic of it when I can!
_________________________

What is this?
------------------
This is a simple visor for the Mazda Connect infotainment display. I made this because I do a lot of driving at night, and despite the lower brightness, the reflection / glare of the screen on my windshield is distracting.

Depending on the angle of your seat and head-height this will obviously vary, but this one is works for me.

Uses between 50-100 grams of material, and recommend coarse layer height for speed of printing. Oh, and don't use PLA for things that go in a car!

___________________________________


Post-Print
-------------
I used 3M outdoor rated adhesive tape to stick it to the back of the screen. Comes off cleanly if needed.
__________________________________________________________________