Thingiverse
MC
by AlVaPa
33
Downloads
21
Likes
0
Makes
The printer has faithfully served for 6 years as a testing ground, endlessly changing its appearance.
As a result, it was decided to put an end to it and freeze it in its current form, even if some nodes can and should be improved.
Now to the point.
Attention! The belt stretched parallel to the Y movement must be reversed. In this case, along its entire length, it will come into contact with the smooth side of the bearings.
Laminated MDF is used as the body.
The frame of the table is assembled on a square tube 20x20 1.5 mm thick. Bearings on the portal XY 608 are the cheapest and most common. Belt GT2 6mm. The portal itself is a two-story CoreXY. All details are designed with an emphasis on the most convenient printing. Cooling and blowing any compatible with E3D V6
As electronics can use any convenient for the user.
The required details are shown in the table.
As a result, it was decided to put an end to it and freeze it in its current form, even if some nodes can and should be improved.
Now to the point.
Attention! The belt stretched parallel to the Y movement must be reversed. In this case, along its entire length, it will come into contact with the smooth side of the bearings.
Laminated MDF is used as the body.
The frame of the table is assembled on a square tube 20x20 1.5 mm thick. Bearings on the portal XY 608 are the cheapest and most common. Belt GT2 6mm. The portal itself is a two-story CoreXY. All details are designed with an emphasis on the most convenient printing. Cooling and blowing any compatible with E3D V6
As electronics can use any convenient for the user.
The required details are shown in the table.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
