Thingiverse
Mechanical Basic Laser Show
by tbmaker90
6
Downloads
4
Likes
0
Makes
I wanted to create this so that way I could use this with a basic laser light purchased at petco. The laser light is very basic and also short. So I created a 2 part sleeve and a switch to fit on it and work with Additive Techs laser show.
All I created was the laser sleeve and the switch. All other files located here are from additive tech. Thanks for a great thing to be able to give to my nephews.
Check out my etsy at https://www.etsy.com/shop/TBMAKER
to see more designs
With these basic files I made all I had to do was take the chain off the laserlight, take of the front cap, add the switch (and verify it works okay) then, add the short sleeve and replace the front cap, then add the long sleeve (you may have to push with a little force) to the rear and attach to the light show kit and I was all set to go.
All I created was the laser sleeve and the switch. All other files located here are from additive tech. Thanks for a great thing to be able to give to my nephews.
Check out my etsy at https://www.etsy.com/shop/TBMAKER
to see more designs
With these basic files I made all I had to do was take the chain off the laserlight, take of the front cap, add the switch (and verify it works okay) then, add the short sleeve and replace the front cap, then add the long sleeve (you may have to push with a little force) to the rear and attach to the light show kit and I was all set to go.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
